Ullrich Aluminium
1st , forming perspex etc , not a job I would do myself...If all good , how did you do it?
Anyway to the question
Had to do a bit of reshaping , positioning, new bottom seal of the screen on the commander...
Bottom edge is mounted on the bottom seal rubber, by cut off alloy 90 deg angle .. about 25 x 25 mm about 17mm wide..
Screwed to top deck/ dash, and screws with nylock thru the bottom of the screen
The top edge, which also has the clips for the bimmini clears fit neat over the top edge of the screen.
Next time , althu may look a bit chunky, I would replace with alloy channel bit heavier...
Reason being is with the clears up, the top of the screen/channel flexes a little too easy...
Times when Im on the capstan, crew on the helm, moving the boat up , over the anchor to lift it... they tend to have 1 hand on the wheel and sort of grab and pull themselves up to see over the screen..
The screen was made by previous owner 12+ yrs ago, off the original, except slightly lower cause they used the original screen as the mould... resulting in the top 'bar going thru ones liner of sight.
Forum Topics
New Posts
Search
FAQ
Register
Login
Topic Options
Post Options
Likes(0)
