


red89mx wrote:I noticed an engine symbol in the RH quadrant as I was trimming up the engine. It blinked on intermittently until I turned the engine off ![]() ![]() |
It is a service code flashing, If it flashes twice then a slight pause then 8 times, then it is the signal for code 28 which is a shift position switch code, it is the most common service code. The gearshift cable will need adjusting correctly so when the gearshift is in neutral the shift slide sits in the middle of the shift position switch.
Trophy snapper in close The snapper fishing out deeper continues to be the most consistent... Read More >
Swords aboard! With some of the smoothest seas and lowest winds we have seen in... Read More >
Kingfish and snapper in the bay Having spent the week weighing kingfish, I decided that... Read More >
Good variety on offer Great to have a couple of trips after a few quiet... Read More >