


red89mx wrote:I noticed an engine symbol in the RH quadrant as I was trimming up the engine. It blinked on intermittently until I turned the engine off ![]() ![]() |
It is a service code flashing, If it flashes twice then a slight pause then 8 times, then it is the signal for code 28 which is a shift position switch code, it is the most common service code. The gearshift cable will need adjusting correctly so when the gearshift is in neutral the shift slide sits in the middle of the shift position switch.
Colder water, hotter fishing As the water temperature has dropped, the pre-dawn air temperature has... Read More >
Snapper everywhere along the coast Harbour snapper are still biting and they are in prime... Read More >
Baits out-fishing lures The high cost of fuel may be deterring a lot of anglers... Read More >
Smorgasbord of fishing options Over the last month, the weather has taken a turn towards... Read More >