SWR meter required?

Post Options Post Options   Likes (0) Likes(0)   Quote mouthu Quote  Post ReplyReply Direct Link To This Post Topic: SWR meter required?
    Posted: 29 Nov 2012 at 3:21pm
mouthu View Drop Down
Titanium
Titanium
Avatar

Joined: 20 May 2007
Location: Westie
Status: Offline
Points: 6359
Anyone got a SWR meter I can borrow in west auckland?
 
If you have to ask what one is, you ain't got one.
 
The reason i  need one is i'm receiving on my vhf but my transmit is crap.
Yes it was me, I screwed it up for everyone.
Back to Top
Post Options Post Options   Likes (0) Likes(0)   Quote Jet_ski_fisher Quote  Post ReplyReply Direct Link To This Post Posted: 29 Nov 2012 at 4:00pm
Jet_ski_fisher View Drop Down
Titanium
Titanium
Avatar

Joined: 08 Dec 2008
Location: Whakatane
Status: Offline
Points: 15
Check the radio out and the connections and cable first. because the vhf ant comes factory tunned. if you cut the copper wire you detune it...not a good thing. and a swr meter will only work if you can cut the copper wire to retune it to get the lowest point on the needle..
Back to Top
Post Options Post Options   Likes (0) Likes(0)   Quote mouthu Quote  Post ReplyReply Direct Link To This Post Posted: 29 Nov 2012 at 5:37pm
mouthu View Drop Down
Titanium
Titanium
Avatar

Joined: 20 May 2007
Location: Westie
Status: Offline
Points: 6359
I know how to use a swr meter.
Yes it was me, I screwed it up for everyone.
Back to Top
Post Options Post Options   Likes (0) Likes(0)   Quote Jet_ski_fisher Quote  Post ReplyReply Direct Link To This Post Posted: 29 Nov 2012 at 6:05pm
Jet_ski_fisher View Drop Down
Titanium
Titanium
Avatar

Joined: 08 Dec 2008
Location: Whakatane
Status: Offline
Points: 15
Thats good :) have fun
Back to Top
Post Options Post Options   Likes (0) Likes(0)   Quote Bay Marine Electronics Quote  Post ReplyReply Direct Link To This Post Posted: 30 Nov 2012 at 10:29pm
Bay Marine Electronics View Drop Down
Gold
Gold
Avatar

Joined: 03 Aug 2011
Status: Offline
Points: 601
Bring it down to Tauranga and we'll test it for ya!

Thats not actually true about cutting the coax leading to the antenna, so long as its longer than about a metre long your sweet as (actually so long as its above a half wavelength, I'm too tired to look it up). Cutting the antenna on the other hand....

If you're recieving clearly from a long range you'll probably find the antenna SWR is ok too, if the antenna is buggered then you'll normally stop recieving as well.
0800 BAY MARINE www.baymarineelectronics.co.nz
Back to Top
Post Options Post Options   Likes (0) Likes(0)   Quote Jet_ski_fisher Quote  Post ReplyReply Direct Link To This Post Posted: 30 Nov 2012 at 11:31pm
Jet_ski_fisher View Drop Down
Titanium
Titanium
Avatar

Joined: 08 Dec 2008
Location: Whakatane
Status: Offline
Points: 15
Correct BME.. but i never typed cutting the cable. only the copper wire that is wrapped around the antenna. I'll bet that it's the cable and or the connection eg plu259. hope they get it fixed been in the same boat and found my one was the unit it's self.. 
Back to Top
Post Options Post Options   Likes (0) Likes(0)   Quote mouthu Quote  Post ReplyReply Direct Link To This Post Posted: 01 Dec 2012 at 8:33am
mouthu View Drop Down
Titanium
Titanium
Avatar

Joined: 20 May 2007
Location: Westie
Status: Offline
Points: 6359
To give you guys an idea if I know what I'm doing, try this on for size...
 
One of my previous 'hobbies' inlcude an antenna with a half wavelenghtof 18 feet sitting on a mastr 46 feet above the horizon on the north shore of auckland with a red light at the top of the mast so flying objects didn't hit it.
I could tune the whole set up from either the plug into the back of my set or the tuning coil at the base of the anettena, bitharder doing that when it's vertical.
 
I could go into how much db loss I had but no one cares.
 
So, as i can't find my swr metre and a few other things like my soldering iron....
 
Yes it was me, I screwed it up for everyone.
Back to Top
Post Options Post Options   Likes (0) Likes(0)   Quote mouthu Quote  Post ReplyReply Direct Link To This Post Posted: 14 Dec 2012 at 1:22pm
mouthu View Drop Down
Titanium
Titanium
Avatar

Joined: 20 May 2007
Location: Westie
Status: Offline
Points: 6359
Just had Mike from Western Auto and Marine here lloking at my set up, good bloke, turns out it's not the antenna at all............. the radio has a fault that only a swr meter would have picked up.
 
Thanks Rob , Bay Marine Electronics, you were right and thanks for the referral.
 
Have spoken to Uniden who made the radio and gave them the serial number and it's still under warranty even though I didn't buy it new.
 
It gets better.
Yes it was me, I screwed it up for everyone.
Back to Top
Post Options Post Options   Likes (0) Likes(0)   Quote Jet_ski_fisher Quote  Post ReplyReply Direct Link To This Post Posted: 14 Dec 2012 at 2:22pm
Jet_ski_fisher View Drop Down
Titanium
Titanium
Avatar

Joined: 08 Dec 2008
Location: Whakatane
Status: Offline
Points: 15
well done and good on uniden for backing up there products. i bet it was the power output side of it that failed...
Back to Top
Forum Jump
Forum Permissions View Drop Down


This page was generated in 0.178 seconds.

Fishing Reports Visit Reports

Saltwater Fishing Reports
Raglan Fishing Report - 12/11/26

Big spring snapper. With the more settled weather over the last couple of weeks there’s... Read More >

12 Nov 2026
Saltwater Fishing Reports
Mercury Bay Fishing Report - 12/11/26

Snapper hit and miss. Most reports have been telling us it’s becoming more difficult to... Read More >

12 Nov 2026
Saltwater Fishing Reports
Northland Fishing Report - 12/11/26

The switch has been flicked on! Call it what you want, El Niño, global warming,... Read More >

12 Nov 2026
Saltwater Fishing Reports
Tauranga Fishing Report - 12/11/26

Snapper and kahawai in close. Again, we start on a positive note, with some nice... Read More >

12 Nov 2026
Fishing bite times Fishing bite times

Major Bites

Minor Bites

Major Bites

Minor Bites