FAQ FAQ  Forum Search   Events   Register Register  Login Login

fighting butt

Post Options Post Options   Likes (0) Likes(0)   Quote gmacx Quote  Post ReplyReply Direct Link To This Post Topic: fighting butt
    Posted: 24 Dec 2014 at 12:04pm
gmacx View Drop Down
Silver
Silver


Joined: 24 May 2012
Status: Online
Points: 264
Hi guys,

Noobie question here - am looking at using an EVA fighting butt like this one http://www.mudhole.com/Rod-Building/Fighting-Butts/SGFBF-2-Tone-Fighting-Butt-for-Split-Grips, have only used the rubber one in the past, is the principle the same?

Buy one that is larger than the blank OD and fill it up?
Or should it be done like an EVA grip and smaller than OD and squeeze it on with epoxy?

Cheers
Back to Top
Post Options Post Options   Likes (0) Likes(0)   Quote MarkE Quote  Post ReplyReply Direct Link To This Post Posted: 24 Dec 2014 at 12:08pm
MarkE View Drop Down
Platinum
Platinum


Joined: 02 Feb 2007
Location: Mudfish Central
Status: Offline
Points: 2897
Buy as close to the Blank diameter as you can (slightly under if possible) and use epoxy as you say.
Sea Strike 18' Centre Console - Under Construction....Build Thread here
Back to Top
Post Options Post Options   Likes (0) Likes(0)   Quote makka Quote  Post ReplyReply Direct Link To This Post Posted: 24 Dec 2014 at 11:28pm
makka View Drop Down
Gold
Gold


Joined: 05 Apr 2010
Location: Wellington
Status: Offline
Points: 779
Buy undersized and ream to fit
Back to Top
Forum Jump
Forum Permissions View Drop Down


This page was generated in 0.117 seconds.