Print Page | Close Window

fighting butt

Printed From: The Fishing Website
Category: Saltwater Fishing
Forum Name: Rod Building
Forum Description: Rod building chat here
URL: https://www.fishing.net.nz/forum/forum_posts.asp?TID=106238
Printed Date: 10 Jun 2026 at 11:35am


Topic: fighting butt
Posted By: gmacx
Subject: fighting butt
Date Posted: 24 Dec 2014 at 12:04pm
Hi guys,

Noobie question here - am looking at using an EVA fighting butt like this one http://www.mudhole.com/Rod-Building/Fighting-Butts/SGFBF-2-Tone-Fighting-Butt-for-Split-Grips" rel="nofollow - http://www.mudhole.com/Rod-Building/Fighting-Butts/SGFBF-2-Tone-Fighting-Butt-for-Split-Grips , have only used the rubber one in the past, is the principle the same?

Buy one that is larger than the blank OD and fill it up?
Or should it be done like an EVA grip and smaller than OD and squeeze it on with epoxy?

Cheers


Replies:
Posted By: MarkE
Date Posted: 24 Dec 2014 at 12:08pm
Buy as close to the Blank diameter as you can (slightly under if possible) and use epoxy as you say.

-------------
Sea Strike 18' Centre Console - Under Construction.... http://www.fishing.net.nz/asp_forums/sea-strike-18-build-thread_topic87723_page1.html" rel="nofollow - Build Thread here

Posted By: makka
Date Posted: 24 Dec 2014 at 11:28pm
Buy undersized and ream to fit


Print Page | Close Window