I have 15 foot CTS CArbon poles and they work fine nice and stiff. I use the system that Bonze recomends with Dacron loops and Blacks clips set to 5kg. There are better clips...! Anyway the releases are nice and snappy and the outriggers don't give much is at all.
I've fished on mates boats using the Kilwell stiff riggers. Very nice looking and similarly stiff. Frankly I'd buy the cheapest between the Kilwell and CTS ones. I don't reckon there's much in it.
I use one piece they're a blessing and a curse, dealing with the halyard rigging when they're out of the bases I have solved by using bungy cords to connect the halyards back to the first guide with the bungy cords.
I can't imagine what a bustup the halyards would be with a 2 piece outrigger. For transport I push them up the guts of my boat until the tips touch the back of the anchor well. and the butts are hanging flush with the transom. Others tie the front to their bow rails and have a couple of custom made supports that go in the rear rod holders.
For bases I have the Ocean Blue ones, but I reckon they're 304 stainles and are about 7 years old now and have rust marks all over them. I don't care but if you do, then I believe Jamie does his Douglas Outriggers in 316.
I may get myself in trouble here, but I think the Kilwell bases are rebadged from a what I thought was a chinese brand that has recently disappeared. They do have a much more user friendly retention and release mechanism. But if they chinese origin, then they're likely to be 304 stainless which will get rust marks over time.
The Ocean Blue bases I have use a Tri-clover clamp with a welded stud that attaches to the superstructure, which has special wing nut on one side, I am conithually paranoid that I'll over undo it at some stage and fumble resulting losing it into the drink. Haven't done it yet in 7 years of use, but the concern is always there. Once you've lost it you're buggered, because they're not sold as spares!
I don't know what Jamie uses on his ones.
Then there are the more expensive and arguably original Rupp and Reflex brands amongst others. These have much better clamp mechanisms again. Which can be useful. They also allow you to tailor the angle of the outrigger. Some people like to run a higher angle on their riggers, whereas my Ocean blue rigger bases run relatively flat. I have often wondered whetehr runn them higher would help, but can't really change it without major surgery.
I've rigged mine with double hal-lock pulleys and run two sets of halyards. the hal-lock pulleys are connected to a trapeze cleat which then hooks to the boat so I can keep my halyards nice and tight for snappy release. I chucked the bungy that comes with teh hal-locks away.