Rod load angles

Post Options Post Options   Likes (0) Likes(0)   Quote ChrisW Quote  Post ReplyReply Direct Link To This Post Topic: Rod load angles
    Posted: 17 Dec 2010 at 11:50am
ChrisW View Drop Down
Forum Sponsor
Forum Sponsor
Avatar

Joined: 10 Sep 2002
Location: Switzerland
Status: Offline
Points: 3812
I came across this illustration which is helpful in explaining graphically rod load angles.
 
 
 
The recommended max height for graphite rods is 45, any higher and there is no real advantage from the rod, only increasing potential for a breakage due to a high sticking.  Some rod manufacturers like Smiths, do say that experienced anglers can push the boundaries up to 60 degrees on certain rods like the GTK stickbait and WRC popper rods.
give it death!
Back to Top
Post Options Post Options   Likes (0) Likes(0)   Quote blackboat Quote  Post ReplyReply Direct Link To This Post Posted: 17 Dec 2010 at 11:57am
blackboat View Drop Down
Titanium
Titanium
Avatar

Joined: 30 Sep 2008
Location: nelson
Status: Offline
Points: 3250
interesting Chris never really thought about it but 45 seems about common and more comfy when fighting a fish 
Back to Top
Post Options Post Options   Likes (0) Likes(0)   Quote Capt Asparagus Quote  Post ReplyReply Direct Link To This Post Posted: 17 Dec 2010 at 11:58am
Capt Asparagus View Drop Down
Titanium
Titanium
Avatar

Joined: 18 Sep 2002
Location: New Zealand
Status: Offline
Points: 13168
Saw an article on that a while back, made a lot of sense. What was interesting was that it showed that if you were fisghting fish going straight down (ish), the best rod to use is a bent butt, as your maximum power/lift angle is in play more than with a straight butt rod. Onl problem with that is that if the fish goes out long on the surface, you have a reverse issue really, it is too difficult to lift the rod tip high enough to be effective. Still, I have a stand-up bent butt set that I used for a while that was just lethal on kingies and puka at the ranfurly and white, until I statrted using smaller reels loaded with braid etc. Hell...., that musta been a fair while ago now! .....tempus fugit!
Back to Top
Post Options Post Options   Likes (0) Likes(0)   Quote Lethal Quote  Post ReplyReply Direct Link To This Post Posted: 17 Dec 2010 at 1:35pm
Lethal View Drop Down
Rest In Peace
Rest In Peace
Avatar

Joined: 28 Oct 2002
Location: In our thoughts
Status: Offline
Points: 23636
i would fish 60% most of the time with a rod that is fast tapper not parabolic....
so i guess it depends on the rod action as well whether you would go any higher...

watching some programs on TV and seeing guys high sticking just makes me cringe, how some of them dont break is beyond me...

i remember a guy complaining about his broken rod and wanted a replacement, he said his mate got it breaking on video,
when i watched it, i just could not believe how far back he bent this rod....
would you believe he was lying on his back with rod at the same angle as his body and line was running over the rail of the charter boat he was fishing from....
now the rod was solid glass which is pretty bullet prof for most dick heads that dont know too much about fishing but that is just going why over the top...


   
 
Thanks for everything you did for us Eric. may you rest in peace, You were one of the real legends of NZ recreational fishing
Back to Top
Post Options Post Options   Likes (0) Likes(0)   Quote Capt Asparagus Quote  Post ReplyReply Direct Link To This Post Posted: 17 Dec 2010 at 2:00pm
Capt Asparagus View Drop Down
Titanium
Titanium
Avatar

Joined: 18 Sep 2002
Location: New Zealand
Status: Offline
Points: 13168
LOL Yes, I have seen some shockers myself, the faith some people have in the unbreakablity of their gear just astounds... What I really love is the point loading you see (as long as it is not a loaner rod I have let someone use of course),,, with rods laid across rails half way up the rod and them speed-jigging for kingies, really cranking on their reels.... one hit from a king and... that makes for a LOT of semi-rods, I can tell you. Or folks using a long rod to try lifting a fish up over a rail and into the boat, shhheeeesshhhhh.... and the look of injured innocence when the inevitable "CRACK!!" comes!
Back to Top
Post Options Post Options   Likes (0) Likes(0)   Quote hookerpuka Quote  Post ReplyReply Direct Link To This Post Posted: 17 Dec 2010 at 2:04pm
hookerpuka View Drop Down
Titanium
Titanium
Avatar

Joined: 20 Jul 2008
Location: New Zealand
Status: Offline
Points: 3439
that diagram looks wrong to me.... the 0% line should be the 45..... since line angle is based on your line not the ocean surface. 
Back to Top
Post Options Post Options   Likes (0) Likes(0)   Quote Muppet Quote  Post ReplyReply Direct Link To This Post Posted: 17 Dec 2010 at 2:16pm
Muppet View Drop Down
Titanium
Titanium
Avatar

Joined: 26 May 2004
Location: NZ
Status: Offline
Points: 19245
I always considor holding my rod straight out as 0 degrees and don't go beyond 45 degrees.
Back to Top
Post Options Post Options   Likes (0) Likes(0)   Quote Adam Scott Quote  Post ReplyReply Direct Link To This Post Posted: 17 Dec 2010 at 2:17pm
Adam Scott View Drop Down
Platinum
Platinum
Avatar

Joined: 17 Jul 2002
Status: Offline
Points: 2813
Originally posted by hookerpuka hookerpuka wrote:

that diagram looks wrong to me.... the 0% line should be the 45..... since line angle is based on your line not the ocean surface. 
Isnt the line angle the same in all of them?
Back to Top
Post Options Post Options   Likes (0) Likes(0)   Quote hookerpuka Quote  Post ReplyReply Direct Link To This Post Posted: 17 Dec 2010 at 2:35pm
hookerpuka View Drop Down
Titanium
Titanium
Avatar

Joined: 20 Jul 2008
Location: New Zealand
Status: Offline
Points: 3439
If it's based around a fish being vertically below the boat like it would appear to be in the 0 degree scenario that would be the 45 degree angle.
Back to Top
Post Options Post Options   Likes (0) Likes(0)   Quote photog Quote  Post ReplyReply Direct Link To This Post Posted: 17 Dec 2010 at 2:40pm
photog View Drop Down
Silver
Silver
Avatar

Joined: 27 Apr 2010
Location: NZ
Status: Offline
Points: 402
Basically the safe area is where the rod feels like its working and is comfortable. High sticking you loose feel and the not only does it get point end loaded but the mid section starts to wonder around. It shouldn't take even a novice long to feel the difference especially when show by someone with more experience. The main danger is when the angler gets the fish close and feels the need to put the tip skywards, bad mistake.
If I'm not taking photos I'm fishing. If I'm not fishing I'm taking photos, either way I'm having fun.
Back to Top
Post Options Post Options   Likes (0) Likes(0)   Quote Falco Quote  Post ReplyReply Direct Link To This Post Posted: 17 Dec 2010 at 9:10pm
Falco View Drop Down
Titanium
Titanium
Avatar

Joined: 24 Feb 2008
Location: Papamoa Beach
Status: Offline
Points: 3319
not sure what HP is on about but im happy with my fisherman with the but section up to 60 degrees
Back to Top
Post Options Post Options   Likes (0) Likes(0)   Quote Espresso Quote  Post ReplyReply Direct Link To This Post Posted: 17 Dec 2010 at 10:17pm
Espresso View Drop Down
Forum Sponsor
Forum Sponsor
Avatar

Joined: 22 Apr 2003
Location: New Zealand
Status: Offline
Points: 7592

I abuse the maximum parameters of my graphite rods regularly Embarrassed , to date haven't broken one because of it...but I don't let others abuse them so! 

I enjoy a good 60degree angle..
Back to Top
Post Options Post Options   Likes (0) Likes(0)   Quote hookerpuka Quote  Post ReplyReply Direct Link To This Post Posted: 18 Dec 2010 at 7:21am
hookerpuka View Drop Down
Titanium
Titanium
Avatar

Joined: 20 Jul 2008
Location: New Zealand
Status: Offline
Points: 3439
Originally posted by falco falco wrote:

not sure what HP is on about but im happy with my fisherman with the but section up to 60 degrees

 Look at a protractor. I'm sure you can work it out :D make the straight edge you line and go from there Wink 
Back to Top
Post Options Post Options   Likes (0) Likes(0)   Quote Fishb8 Quote  Post ReplyReply Direct Link To This Post Posted: 18 Dec 2010 at 7:24am
Fishb8 View Drop Down
Titanium
Titanium
Avatar

Joined: 17 Jul 2002
Location: Hamilton
Status: Offline
Points: 9396
I've gone U-shaped on graphite fly rods but you don't get any more pulling power - I've checked by connecting to scales and having someone read.
That's an exercise worth doing to check drag and rod bend.
Be yourself; everyone else is already taken
Back to Top
Post Options Post Options   Likes (0) Likes(0)   Quote ThomasW Quote  Post ReplyReply Direct Link To This Post Posted: 18 Dec 2010 at 8:27am
ThomasW View Drop Down
Titanium
Titanium
Avatar

Joined: 03 Dec 2005
Location: Byelorussian SSR
Status: Offline
Points: 6349
I am certain I go past 60 degrees on my surf rods when playing fish, but automatically reduce the angle if the fish starts to run.
Back to Top
Post Options Post Options   Likes (0) Likes(0)   Quote Capt Asparagus Quote  Post ReplyReply Direct Link To This Post Posted: 18 Dec 2010 at 9:54am
Capt Asparagus View Drop Down
Titanium
Titanium
Avatar

Joined: 18 Sep 2002
Location: New Zealand
Status: Offline
Points: 13168
If you are over 60deg, and the fish starts to really run, then wouldn't the load go lower down the rod, making for a more parabolic (sorta) shape, reducing the point loading on the rod tip section? If there was bugger all pull on the rod and it was only the tip being bent down, that'd be the meanest point loading then wouldn't it, right at the most delicate part of the rod? Then as you get closer to 90deg or worse, all the load would just transfer straight back to the tip again, and for sure go blammo....
Back to Top
Post Options Post Options   Likes (0) Likes(0)   Quote Cbro Quote  Post ReplyReply Direct Link To This Post Posted: 18 Dec 2010 at 2:10pm
Cbro View Drop Down
Platinum
Platinum
Avatar

Joined: 23 Oct 2008
Location: Far North
Status: Offline
Points: 2501
No I think the point is that after 45 you lose the parabolic shape and the load increases on the middle top section with the load increasingly going towards the tip as the angle gets increased.

The further away the line angle the higher you can lift the rod...

Quick diagram from my understanding...please correct me if im wrong?


Back to Top
Post Options Post Options   Likes (0) Likes(0)   Quote Capt Asparagus Quote  Post ReplyReply Direct Link To This Post Posted: 18 Dec 2010 at 2:35pm
Capt Asparagus View Drop Down
Titanium
Titanium
Avatar

Joined: 18 Sep 2002
Location: New Zealand
Status: Offline
Points: 13168
Yep, that seems pretty good.
Back to Top
Forum Jump
Forum Permissions View Drop Down


This page was generated in 0.258 seconds.

Fishing Reports Visit Reports

Saltwater Fishing Reports
Bream Bay Fishing Report - 14/05/26

Move over snapper, the trevs are here While for many of us snapper are a... Read More >

14 May 2026
Freshwater Fishing Reports
Rotorua Fishing Report - 14/05/26

Season of change For the Rotorua region we are in a transitional stage with the... Read More >

14 May 2026
Saltwater Fishing Reports
Outer Hauraki Gulf Fishing Report 14/05/26

Perseverance pays off As the calendar edges deeper into May, the outer reaches of the... Read More >

14 May 2026
Freshwater Fishing Reports
Canterbury Fishing Report - 14/05/26

Autumn has well and truly arrived Autumn has well and truly arrived; these days are... Read More >

14 May 2026
Saltwater Fishing Reports
Bay of Islands Fishing Report - 14/05/26

Yellowfin still here! Can you believe it? A yellowfin tuna was caught last Friday and... Read More >

14 May 2026
Saltwater Fishing Reports
Tauranga Fishing Report - 14/05/26

Harbour and beaches producing The weather has at least let us get out after a... Read More >

14 May 2026
Fishing bite times Fishing bite times

Major Bites

Minor Bites

Major Bites

Minor Bites