Alan L wrote: Been giving my reels a bit of TLC. Well to be honest one was complaining, so one thing lead to another. Stripped the 2 spd TLD 30 down. No real issues - but it was a bit stiff on winding the spool with drag on. Thought was prob lack of use over winter months. Pulled it apart, re lubed everything, and still doing same. More drag I put on, the stiffness in turning the handle increases. I am guessing it is pulling the drag washer tight against the clutch plate, but can't figure why it would increase the resistance to winding. Anyone had this? It is only slightly stiff, but on a decent fight it would be a PITA. A shim issue? Thanks Alan |
Rozboon wrote: I'd almost guarantee it will be the right side plate pinion bearing. They just eventually get squashed because the whole spool shaft and drag system compresses against them when you push the drag lever forward. Only way around it is thrust bearings which a small number of reels have. It will only be getting stiff under axial load so is kinda hard to replicate. |
metuljnicsn wrote: Al, had similar issues with some lever drag reels before but for life of me I cant fully remember the cause, someone may correct me but I think you will find its a bearing issue. Most likely the bearing that is in the side plate housing. |
Skoti wrote:
Word for word Tzers post above . |
smudge wrote: I saw that this morning Skoti, and thought it was a dodgy member profile. Well spotted. And he's just been fried |
Change in seasons, change in tactics Not a lot to report in the ‘big fish’... Read More >
Fish galore! Coming off the back of Easter Weekend and with some very nice weather... Read More >
Excellent snapper action There is some excellent autumn snapper fishing straight out and up the... Read More >
Whangarei Harbour fishing well Like the weather, the fishing has been patchy throughout Bream Bay... Read More >