Trailer lights rewiring
Printed From: The Fishing Website
Category: General Forums
Forum Name: Tech Topics
Forum Description: IT - Computers, software, phones, ISP's....
URL: https://www.fishing.net.nz/forum/forum_posts.asp?TID=122739
Printed Date: 21 Nov 2026 at 11:48am
Topic: Trailer lights rewiring
Posted By: John_B
Subject: Trailer lights rewiring
Date Posted: 02 Jan 2017 at 6:42pm
Evening guys
Im a complete dummy when it comes to wiring so apologies for total ignorance.
Question - i know the green and yellows are indicator connections, white for earth, red for brakes and brown for tail lights. But what is the brown with white stripe for?
tks in advance
|
Replies:
Posted By: Olfart
Date Posted: 02 Jan 2017 at 7:44pm
Accessories like reversing lights
------------- Semper in excreta sumus, solum profundum variat....
|
Posted By: John_B
Date Posted: 02 Jan 2017 at 8:09pm
Posted By: Steps
Date Posted: 03 Jan 2017 at 9:50am
I suggest, espec in marine conditions , to run cables down each side from the connector....to the lights each side. Then across a trailer cross member between the lights. If one side / connection fails you have a back up circuit. Dont use cable heavier gauge than required
Make sure that you have more than needed excess length cable between
trailer and where plugs into vehicle....not all vehicles have the plug
the same side position....
Make all connection tidy... bit of practice getting stripped the right length.. so strip a little more than think and cut to length as needed.
When have all sorted , working...and covers off.. a light spray of of aerosol lanolin, connectors, bulb holders etc to slow down corrosion dramatically. A good quality insulation tape on the outside of lights, tight around the join between the lens and the back.
Regular maintenance after each trip a quick spray with a CRC type product of connectors.. hitch padlocks, roller, wheel nuts etc.
The lanolin aerosol is not cheap... also use... even mist spray couple times a yr on a cold dry engine and the hydrolic tilt area. Do NOT get any of these sprays on the sacrfical anodes
|
Posted By: John_B
Date Posted: 03 Jan 2017 at 10:38am
tks Steps
very useful
today's project.
|
|