Print Page | Close Window

Thru hull transducer placement

Printed From: The Fishing Website
Category: General Forums
Forum Name: Tech Topics
Forum Description: IT - Computers, software, phones, ISP's....
URL: https://www.fishing.net.nz/forum/forum_posts.asp?TID=121194
Printed Date: 21 Nov 2026 at 11:48am


Topic: Thru hull transducer placement
Posted By: Fizz
Subject: Thru hull transducer placement
Date Posted: 17 Sep 2016 at 11:13am
I got a little excited the other week and purchased a b260 thru hull transducer with the performance fairing.
Now I see I have but one position to mount it- directly on the keel line of the boat-(7metre fibreglass Bertram on a trailer) with a single engine stern drive
Looking at the instructions tells me I have to mount it off to one side of the propellor.
This while possible would require reconfiguring(see chop-weld) of the four rear wobble rollers and would still only offset the transducer by maybe 150mm.
My question is has anyone run these on a single prop boat in line with the leg with success?
Or am I just plain daft?

-------------
Boat Name- Solace



Replies:
Posted By: Tagit
Date Posted: 17 Sep 2016 at 3:49pm
I just fitted one of those to a 45ft power cat. Couldn't use the fairing as the cat has a 35deg deadrise and those fairing won't cut to that angle. Had to make our own adapter for the 35deg hull.

That's a seriously big fairing for a 7m boat so I would be careful about getting the placement right as it will disturb a decent amount of water. I can't tell your for sure whether putting it in line with the prop would be an issue, but my guy feeling is saying that it probably wouldn't be a good idea.


Posted By: Fizz
Date Posted: 17 Sep 2016 at 6:06pm
And on that note- those pesky wobble rollers are getting the elbow!

-------------
Boat Name- Solace


Posted By: Tagit
Date Posted: 17 Sep 2016 at 7:02pm
That's what I would be doing. Better safe than sorry. We cruise that boat about 18knts and the high speed fairing isn't missed at that speed. We just made an angle adapter out of hardwood to get the transducer pointing straight down. That wasn't a 5 minute job however and accuracy in the cut is pretty critical.


Posted By: Fizz
Date Posted: 09 Feb 2017 at 3:15pm
sheesh i forgot i even posted in here!
UPDATE

so i moved and modified the wobble rollers and fitted the transducer to one side of the hull with its high speed fairing to the hull, and it works amazingly at all speeds- no problems with the propellor cavitating or airating(whichever is the correct term here.)

winning


-------------
Boat Name- Solace



Print Page | Close Window