Print Page | Close Window

Fuel consumption

Printed From: The Fishing Website
Category: General Forums
Forum Name: Tech Topics
Forum Description: IT - Computers, software, phones, ISP's....
URL: https://www.fishing.net.nz/forum/forum_posts.asp?TID=116521
Printed Date: 20 Nov 2026 at 9:54am


Topic: Fuel consumption
Posted By: AdAstra
Subject: Fuel consumption
Date Posted: 09 Mar 2016 at 9:32am
Hi.
Can anyone out there give me an idea of the expected fuel burn from a 2000 115hp Johnson pushing a 5.2M Fi Glass Warrior.
I kinda hope it is less than the 175hp Black Max that pushed an elderly HH V19 which I have just moved on.

Cheers



Replies:
Posted By: Otto
Date Posted: 09 Mar 2016 at 9:40am
Lots a fuel rates here,  maybe of help
http://www.fishing.net.nz/forum/fuel-flow-and-economy-figures_topic26102_page19.html" rel="nofollow - http://www.fishing.net.nz/forum/fuel-flow-and-economy-figures_topic26102_page19.html


Posted By: Steps
Date Posted: 09 Mar 2016 at 5:52pm
On ave better than 1.25 nm per L.. closer to 1 nm per L
If propped right....
Power wise u are min plus a little more .....
If engine mounted right height.. ie a few droppets of water run over the cavitation plate fully trimed at cruise....a prop with good grip and around 19" pitch.
That should give u around 5000/ 5100 rpms WoT fully trimed.


Posted By: Tagit
Date Posted: 09 Mar 2016 at 6:36pm
If correctly propped to reach the right max rpm figure at WOT, I would guess around 25lph @ 4000rpm cruise with 2 pob. More if loaded up. If you are much worse than this figure I would be looking at engine heights, props etc.


Posted By: AdAstra
Date Posted: 13 Mar 2016 at 7:18am
Thanks all for your info. I guess time will tell once I log a few hours.




Posted By: Steps
Date Posted: 13 Mar 2016 at 11:32am
Ditto on Tagits comments....
I prefer the old  'miles per gallon' rather than L per hr on a general use, family type boat... an over all ave use.
 like a car, L per hr at different rpms and loads vary hugely....and over a few100 miles one gets a broad ave of everything from chugging thru moorings, cruising, going back to re drift a spot, and pulling back when chopps up to cross the straight on the way home.
L/hr is good to know when speeding long periods at a constant speed... say a gin place cruising to the barrier or bay of islands or trawling all day for marlin.


Posted By: AdAstra
Date Posted: 13 Mar 2016 at 12:36pm
As well knowing the cost, I want to find out the range of the boat.
It's fitted with a 100lt under-floor tank but no gauge.
Unless the sea is unusually flat, the home made dip stick is of little use too.

Thanks all the same 


Posted By: Steps
Date Posted: 13 Mar 2016 at 7:42pm
As rule, I keep a min of 1/4 in 'reserve' ie if tank holds 100L (mine holds 120) I know my miles per gal ... and work on a max distance for 75L.
Before re propping a trip from maretai up around gannet, down outside shag back home thru ruth would go thru over 70L.. now around the 40/ 42L.
And if hit chop on the way home rpms down around the 3200/ 3500.. more closer to 38 to 40L

How sure are u it holds 100L?
I was told mine was a 110L  lifted the floor and measured its dimensions and was a smidgen under 120L....I also found how much I could get in at the pump depended on what pump/ service station/ direction I faced.
ie not all forecourts are level, and the tank is not level bow to stern in the boat. If the front of the tank is higher a air lock forms before the tank is full.



Posted By: AdAstra
Date Posted: 14 Mar 2016 at 7:53am
Like you Steps, I keep a % in reserve.
tank capacity was determined by the measurements. They arrived at 108 lt.
So I knocked off the 8 lt and called it 100..
I then took off 10lts as a 'fudge factor' and arrived at 90. This is my working capacity.
Until I can arrive at a realistic fuel burn, I also take a 20lt fuel can!
Going out this morning so will be able to get first impressions of this and compare it to my last. A 175hp Black Max, pushing a larger and heavier boat!
Thanks for your input



Print Page | Close Window