Print Page | Close Window

Trailer Wheel Bearings

Printed From: The Fishing Website
Category: General Forums
Forum Name: Tech Topics
Forum Description: IT - Computers, software, phones, ISP's....
URL: https://www.fishing.net.nz/forum/forum_posts.asp?TID=109115
Printed Date: 20 Nov 2026 at 2:54pm


Topic: Trailer Wheel Bearings
Posted By: Boyo
Subject: Trailer Wheel Bearings
Date Posted: 13 May 2015 at 12:20pm
Hello All
I am about to replace the wheel bearings on my boat trailer and am considering fitting bearing buddies afterwards. What are the pros and cons of bearing buddies?



Replies:
Posted By: MacSkipper
Date Posted: 13 May 2015 at 1:51pm
I have bearing buddies on both my trailers - love em.  First trailer put on from almost new - 8 years now no problems never taken wheel hub off to grease or service.
Make sure you get the newer style ones (Trojan are and I think they all are now) that have a pressure release - either a spring loaded nipple and/or overflow port.  Main Problem is forcing to much grease in and blowing back seal behind bearing out and thus letting water in.  Only need to be greased a few times a year until excess grease starts to come out.

-------------
Good fishing trip nothing breaks, great trip catch fish.


Posted By: Boyo
Date Posted: 13 May 2015 at 4:10pm
Thanks John, I appreciate your thoughts.


Posted By: Steps
Date Posted: 13 May 2015 at 5:13pm
Agree...
make sure u use the submersible rear seals .. not the std automotive rear seals.
And a quality marine bearing grease such as the Evenrude triple guard bearing grease... not the blue crap from bunings , super cheap type outlets.
Do not over tighten the castle nut, but do not have any play either.

lot detailed info in older threads


Posted By: CEEBEE
Date Posted: 26 May 2015 at 11:26am
I have fitted BB to all my trailewrs in the past and from that point on never had to replace any wheel bearings. The longest I have had them fitted without a problem was 12 years!!

As others have mentioned having the correct seals and water proof grease is paramount. Ensure when you pump them to be very careful you do NOT over grease or you will blow the rear seal for sure.

An indicator is to watch the grease nipple approach the outer hub and stop just short. You should still be able to move the nipple and disc a little.


-------------
I STARTED THE DAY WITH NO FISH AND I STILL HAVE PLENTY LEFT



Print Page | Close Window