Print Page | Close Window

hds 10 / transducer setup

Printed From: The Fishing Website
Category: General Forums
Forum Name: Tech Topics
Forum Description: IT - Computers, software, phones, ISP's....
URL: https://www.fishing.net.nz/forum/forum_posts.asp?TID=108842
Printed Date: 20 Nov 2026 at 6:05pm


Topic: hds 10 / transducer setup
Posted By: advtracing
Subject: hds 10 / transducer setup
Date Posted: 27 Apr 2015 at 5:14pm
Just installing a hds 10 gen 2 with structure scan on a 17ft ali , the details advise that the transducers should be no greater then 300mm apart but how close can they go to each other ? i'm guessing that as long as they are out of each others beam angles all's good ?



Replies:
Posted By: CEEBEE
Date Posted: 26 May 2015 at 11:28am
I would email / call ENL for advice.

-------------
I STARTED THE DAY WITH NO FISH AND I STILL HAVE PLENTY LEFT


Posted By: advtracing
Date Posted: 28 May 2015 at 12:35pm
caught up with navco at the boat show , asked a few questions in great detail.  asked if the adverts were doctored to make the images look better than real life use ....didn't go down well , anyway since talked to the usa , got a cheat sheet of settings for best use updated the unit with the lastest software and will get out for a check at some point 


Posted By: advtracing
Date Posted: 12 Jul 2015 at 10:29am
Had a few interesting issue with this unit , manly that it would not fire up , screen on and trying but stuck. Looking online this is a common prob. in the usa and alot of people either regularly doing hard resets or sending the units back for replacment.
Mine has crashed since the lastest software up date , neither soft reset or hard reset will work.  soft i reloaded the update again , loaded onto a sd card and reloaded it again in to the unit over riding the last load up. With this the unit is working well again.  A bit like laptops these have issues....

I also got a master settings list from the usa that gives the best results for the unit and side scan , can load up if anyone want it.


Posted By: inmotion
Date Posted: 02 Nov 2015 at 10:39am
Hi
I have one of these units as well. Got it last year but never put the structure scan on as I had no room left on transom. Got new Haines 660 to sort that problem out!
Definitely interested in any cheat sheets you have.
Di you get a definitive answer on how close the transducers can be ?
Am just about to install latest firmware as well. Fingers crossed



Print Page | Close Window