Steps wrote: "On later model motors this fuse was replaced with a fusable link." Cool that may answer a question I dont need to know, but may in the future. I had a couple electrical issues with my Jonny tilt...Alsorted. I followed the whole circuit diagrams around see how stuff works.. In there I rem a fusable link inside the loom. Is this what they look like? |
Mo-Mac1 wrote: It was sitting on the outside of the power head in the cowling on the fuel pump side of the motor. It was running perfect 2 weeks earlier. So after the fault I have: Striped and cleaned carbs, replaced fuel pump diaphragm. Checked timing and carb settings. New magneto/coil under the flywheel. Check flywheel magnets. Tried disconnecting sparkplug leads but all 3 have a similar effect. 2 of the 3 cylinders seem oily. Compression test all 3 are the same, about 118 psi. |
Tasman and Golden Bay snapper still running hot We are not far away from daylight... Read More >
Variety is the spice of life On one recent trip, the plan was to spend a... Read More >
Fish where the fish are! Catching fish or just going fishing? I tackle this issue... Read More >
Thoughtful tactics required for better fish Over the course of each year the fishing varies,... Read More >