The Fishing Website : Discussion Forums : cutting down a blank

cutting down a blank : as badfish said - tape it and...

Thu, 15 Sep 2011 15:18:17 +0000

Author: gtrbaby
Subject: 70070
Posted: 15 Sep 2011 at 3:18pm

as badfish said - tape it and then cut through the tape - it stops the blank from "splintering" at the cut.

cutting down a blank : Yea your onto it, I like to tape...

Thu, 15 Sep 2011 15:10:56 +0000

Author: Badfish
Subject: 70070
Posted: 15 Sep 2011 at 3:10pm

Yea your onto it, I like to tape up the area where I'm cutting and cut thru the tape. I usually use a dremel but sometimes use a hacksaw too.

cutting down a blank : as the title says im want to cut...

Thu, 15 Sep 2011 14:43:08 +0000

Author: smizz
Subject: 70070
Posted: 15 Sep 2011 at 2:43pm

as the title says im want to cut down a blank i have and was just wondering what is the best way should i use a fine hacksaw or an angle grinder i have a couple of thin 1ml cutting blades. i was just going to mask the length i wanted and cut with grinder