Servicing: Overhead Reels

  • James Gibbons

Large Lever Drag

With winter having well and truly arrived, so too have the bluefin! While the fair-weather fishermen have put their rods and reels away for the winter, the brave and adventurous ‘Reel Men’ recently headed off to the east coast in search of the elusive southern bluefin tuna.

Lever drag reels used for trolling have one of the toughest lives any reel can have. Constantly in the gunwale, with saltwater splashing over them and the sun beating down – drying the saltwater in a matter of minutes – and hours away from fresh water and a clean. Then there is the pressure on internal components once hooked to a fish! While these reels are built tough, they aren’t invincible. That is why keeping up with general maintenance in between services is essential. With this in mind, I’m going to give you some essential tips to look after your larger lever drag reels using the Deuthlon Starter Kit to keep them hassle-free between services.

----- Advertisement -----


For large lever drag reels, the Deuthlon cast lube, ceramic, and high-speed bearing oil provided in the Deuthlon Starter Kit can be used to maintain the following parts. Deuthlon does a generic reel lube which can also be used for the following areas at a great price point. 

• Handle 
• Drag Clicker 
• Two Speed Mechanism
• Strike Stopper

Deuthlon Semi Fluid Grease can be used in the following areas:

• Handle 
• Reel Seat 
• Base of the spool before spooling 

Step 1: Apply a couple of drops of Deuthlon Oil at the base of the handle shaft and handle knob; turn the handle knob to get the oil seeping into it the required space. These reels do not have bearings in the handle but require lubrication to prevent saltwater intrusion, which causes corrosion and seizing. After oiling for better protection, you can mix a small amount of Deuthlon Semi Fluid Grease and Deuthlon Oil to apply to the opening between the handle and shaft. This will act as a further barrier to prevent saltwater ingress. 

 

Step 2: Remove the two screws covering the handle cap with a small screwdriver. Apply a couple of drops of oil between the handle knob and handle shaft, and turn the handle knob. You can then use a small amount of the Deuthlon Semi Fluid grease to seal this access point. This is an excellent light grease that will mix with the oil over time and seep further down the handle shaft without causing the handle to gum up and become tight to turn. When replacing the cap and screwing in place, do not over-tighten screws.

----- Advertisement -----


 

Step 3: If your reel has a two-speed function, you can apply a couple of drops to the two-speed pin and plate. Clicking it in and out of gears will help seep the oil in between the plates if you wish to take this apart on such reels as Shimano TLD and Tiagras to apply a coat of light grease.

 

Step 4: A point often missed when maintaining a large lever drag is the lever stop points. On this Shimano TLD50A shown, there is one at the free spool and one at strike. Saltwater can get into these points and then dry, causing it to be tough to press in. Apply a few drops around the edge of the buttons and press a few times to seep in.

 

Step 5: Opposite the handle side of your reel, you’ll find your clicker mechanism. Apply a couple of drops around the switch and slide back and forth. These will ensure it is easy to slide in future and prevent saltwater from penetrating and then drying out, causing a seized solid clicker. 


Handy Tips: 

#1- A coat of Deuthlon Semi Fluid grease can be applied to the base of the spool before spooling with line. This helps prevent corrosion when saltwater eventually seeps down through the line/side of the spool and sits for an extended period. More critical for people using these reels for deep drops, as a more significant amount of wet line is rewound onto the spool. Run warm (not cold) water over your spool to help break down any salt on your line. 

#2 - I learnt the following trick from Tony Orton some years ago; he has a great video of it on his Journey of a Fisherman site. By applying a coating of grease (in this case Deuthlon Semi Fluid Grease) on your reel seat and rod, then place a greased rectangle section of anti-slip matting in between the two. This matting is readily available at most marine shops, commonly used on dashboards and tables. This helps to prevent your reel from seizing solid onto your rod. How often do you remove your game reels from the rods? If, like me, only when getting it serviced! For a trolling combo, that is quite a lot of time with saltwater causing damage. By doing this, it makes removal a breeze!

Doing these simple steps often can be the difference between a straightforward service and a costly repair bill. The Deuthlon Starter Kit is a small price to pay to increase the longevity of your hard-earned fishing gear.


For more on servicing spin reels: 

https://www.fishing.net.nz/fishing-advice/product-news-and-reviews/servicing-spin-reels/


July 2022 - James Gibbons
New Zealand Fishing News Magazine.
Copyright: NZ Fishing Media Ltd.
Re-publishing elsewhere is prohibited

Rate this

Comments

Post a Comment

Required Field

Fishing bite times Fishing bite times

Major Bites

Minor Bites

Major Bites

Minor Bites

Fishing Reports Visit Reports

Saltwater Fishing Reports
Top of the South Fishing Report - 22/03/24

Tasman and Golden Bay snapper still running hot We are not far away from daylight... Read More >

22 Mar 2024
Saltwater Fishing Reports
Bay of Islands Fishing Report - 22/03/24

Variety is the spice of life On one recent trip, the plan was to spend a... Read More >

22 Mar 2024
Saltwater Fishing Reports
Hauraki Gulf Fishing Report - 22/03/24

Fish where the fish are! Catching fish or just going fishing? I tackle this issue... Read More >

22 Mar 2024
Saltwater Fishing Reports
Inner Hauraki Gulf Fishing Report - 22/03/24

Thoughtful tactics required for better fish Over the course of each year the fishing varies,... Read More >

22 Mar 2024

Fishing Reports, News & Specials

Popular Articles

Softbait Fishing - Part 1 - gear selection

John Eichlesheim writes an article about selecting the right equipment for softbait fishing... Read More >

Softbait fishing Pt 2 - tips and tricks

Techniques, tips and tricks of softbait fishing – getting the most from your soft baits.... Read More >

Surfcasting - setting yourself up

Gary Kemsley helps sort out the necessary gear for intending surf fishers.... Read More >

Squid - How to catch them

Squid fishing is a rapidly growing aspect of fishing - Paul Senior shares some hints and tips to get started.... Read More >